32 41 435 Removing and Installing/Replacing ARS Return Line In Wheel Arch

32 41 435 Removing And Installing/Replacing ARS Return (Part 1)

Special tools required:







WARNING:
Danger of poisoning if oil is ingested/absorbed through the skin.
Risk of injury if oil comes into contact with eyes and skin.

IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Do not draw off hydraulic fluid (risk of contamination).
Close off line connections with seal plug 32 1 270







Recycling:
Catch and dispose of hydraulic fluid in a suitable collecting vessel.







Necessary preliminary tasks:
- Remove front right wheel arch cover
- Remove underbody protection at front and rear
- Remove right steering assembly cover
- Release front right underbody panelling







IMPORTANT: Pressure lines must be closed off with suitable seal plugs 32 1 270 immediately after removal.







Release screw (1) for return line.







Installation note:

IMPORTANT:
When tightening the screw connection (1), apply counter support with wrench (3) at the line (2).
Non-compliance will result in damage to the line (2).
Tightening torque 37 13 12AZ.







Release line clips (1) and (2) from front axle support.







Release screw (1) in area of lower wishbone.
Tightening torque 32 41 15AZ.







IMPORTANT:
When assembling, make sure that in succession only the seal plugs of the line to be fitted are removed.
When fitting lines, do not tilt connectors (sealing rings.) and connect fully before screwing.
Do not replace sealing rings on hydraulic lines.
Replace affected line if sealing ring is damaged.







After installation:
- Carry out initial Dynamic Drive operation
- Check line connections for tightness

�Z�: