61 12 004 Replacing Battery Positive Lead (From Luggage Compartment Connector to Engine Bulkhead Connector)

61 12 004 - Replacing battery positive lead (from luggage compartment connector to engine bulkhead connector)





Warning!
Observe safety instructions for handling vehicle battery.
Read and comply with notes on handling wiring harnesses 61 00 ... Notes on Handling Wiring Harnesses and Cables and cables.





Necessary preliminary tasks:
- Remove luggage compartment floor trim panel 51 47 101 Removing and Installing/Replacing Luggage Compartment Floor Trim Panel
- Disconnect battery negative lead 61 20 900 Disconnecting and Connecting Battery Negative Lead





Release screw (1).
Tightening torque 61 12 3AZ [1][2]Battery Cable.
Unfasten plug connection (2) and disconnect.





Feed out vacuum hose (1).
Release nuts (2).
Release all screws.
Remove heat shield (3) towards bottom.





Feed out battery positive leads (1) towards bottom.





Unscrew nuts (1).
Release cable tie and remove cover (2).





Release cable holder (1).





Unscrew nuts (1).
Remove duct cover (2).





Release cable holder (1).





Release screws (1).
Remove electronics box cover (2).





Unfasten plug connection (1) and disconnect.
Remove battery positive lead with wiring harness grommet (2) from electronics box.

Installation Note:
Make sure wiring harness grommets (2) are correctly seated in electronics box.





Remove cover cap (1) from B+ terminal.





Slacken nut (1).
Tightening torque 61 12 2AZ [1][2]Battery Cable.
Remove battery positive lead in downward direction.