Seat Belt: Service and Repair

72 11 033 - Removing and installing/replacing front left or right seat belt





Necessary preliminary tasks:
- Remove rear side trim panel 51 43 120 Removing and Installing/Replacing Rear Left or Right Side Trim Panel





Installation:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use





Move seat fully upwards.
Unlock release tab (2) for belt anchor fitting trim (1) with plastic wedge.
Simultaneously unclip trim (1) in direction of arrow.





Release screw (1).
Tightening torque 72 11 02AZ [1][2]Seat Belt Systems.
Remove hook (2) for lower belt guide.





Release screw (1).
Tightening torque 72 11 03AZ [1][2]Seat Belt Systems.
Remove deflection fitting (2).

Installation:
Deflection fitting (2) is coded against incorrect installation.





Release screw (1).
Tightening torque 72 12 01AZ [1][2]Seat Belt Systems.
US only:
Unlock plug connection (3) and disconnect.
Remove inertia reel unit (2).

Installation:
Inertia reel unit (2) is coded against incorrect installation.