54 10 260 Removing and Installing Front Section of the Panorama Glass Roof

54 10 260 Removing And Installing Front Section Of The Panorama Glass Roof

Special tools required:







Necessary preliminary work:
- Remove headlining
- Remove front glass slide/tilt sunroof cover
- Open tailgate

IMPORTANT: Two persons are required to help in removing the glass slide/tilt sunroof.







IMPORTANT:
- Risk of damage.
- Removed front section of panorama glass roof must only be placed on a level support.
- Do not rest front section of the panorama glass roof on the cross members.
- Lay front section of the panorama glass roof broadly across side frame.
- Do not rest front section of panorama glass roof on seals.







Only with optional equipment load area net:
Release screws (1).
Tightening torque 51 24 11AZ.
Remove mounting for load area net:







IMPORTANT: Read and comply with notes on protection against electrostatic discharge (ESD protection).







Unfasten plug connection (1) and disconnect.

Installation note:
Initialise glass slide/tilt sunroof.







IMPORTANT: Airbag lead must not be damaged.

Detach metal tab clips with airbag lead from glass slide/tilt sunroof frame.

Installation note:
Lay airbag lead without tension or kinks.







- Detach water drain hoses (1)

NOTE: Check hoses for damage and coat with water before installation

- Release screws in marked area
Tightening torque 54 12 02AZ.







- An assistant must secure glass slide/tilt sunroof to prevent it falling out.
- Release screws in marked area and carefully lower glass slide/tilt sunroof.
Tightening torque 54 12 02AZ.

IMPORTANT: Do not damage any surrounding components when removing the glass slide/tilt sunroof.

- Remove glass slide/tilt sunroof completely (through rear tailgate).







Replacement:
- Carry out vehicle programming/encoding

Installation note:
If necessary, remove fabric adhesive tape.
To stop creaking noises, secure all screws (1) prior to installation with plastic washers (2).
If the standard screws can no longer grip, use "repair screws" (have larger threads).







IMPORTANT:
- Do not crush any cables when installing the glass slide/tilt sunroof.
- Initialize glass slide/tilt sunroof.







Installation note:
Place front section of panorama glass roof straight upwards on body aperture.
Seal (1) of the front section of the panorama glass roof must face outwards.
Seal (2) of rear glass slide/tilt sunroof cover must extend over front seal (1).







Installation note:
To align the panorama glass roof to the body aperture, insert screws and tighten loosely.
The panorama glass roof must still be able to move in the body aperture.
On account of leaks, the panorama glass roof must be exactly aligned to body aperture.
Insert special tool 54 1 110 into the centring bore as far as it will go in the panorama glass roof and body.
Tighten down screws.
Tightening torque 54 12 02AZ.

IMPORTANT:
- Do not crush any cables when installing the glass slide/tilt sunroof.
- Initialize glass slide/tilt sunroof.

���S: