61 62 030 Removing and Installing/Replacing Wiper Arm on Rear Window

61 62 030 Removing and installing/replacing wiper arm on rear window







Fold up protective cap (1) in direction of arrow.
If necessary, spread internal fixtures (2) as illustrated and remove protective cap (1).







Fixture (1) and latch mechanisms (2) of protective cap (3) must not be damaged.







Erect wiper arm (1).
Release nut (2) and detach wiper arm (1).
Tightening torque 61 62 1AZ.







Installation note:
Wiper motor must be in its end position.
Set dimension (A) to between middle of wiper arm and rear window edge.
Measurement (A): 30 mm.
Tighten nut of wiper arm with specified torque.
Tightening torque 61 62 1AZ.
Check wiper blade for damage and replace if necessary.