51 14 111 Replacing Model Name Plate, Rear

51 14 111 Replacing Model Name Plate, Rear







IMPORTANT: The Instructions for adhering badge emblem serve as the basis for these repair instructions and must be followed without fail.







1 = Model name plate
2 = Adhesive tape
3 = Point of intersection (upper outer corner point of model name plate (1) with dimension "x" to side edge of rear lid)

Attach the upper edge of the adhesive tape (2) offset upward by dimension "y" horizontally to the tailgate edge.
Secure the model designation (1) as follows:
- Lower edge of model name plate (1) with upper edge of adhesive tape (2)
- Outer upper corner point of model name plate (1) with point of intersection (3)

Affix model name plate (1).
Remove adhesive tape (2).