28 10 020 Removing and Installing or Replacing Combination Sensor (GS7D36SG)

28 10 020 Removing And Installing Or Replacing Combination Sensor (GS7D36SG)







IMPORTANT:
After completion of work, check transmission oil level.
Use only the approved transmission oil.
Failure to comply with this instruction will result in serious damage to the twin-clutch gearbox.







IMPORTANT: Read and comply with notes on protection against electrostatic discharge (ESP protection).







Necessary preliminary tasks:
- Remove twin-clutch gearbox
- Remove clutch







Release screw (1).
Tightening torque 28 10 6AZ.
Release combination sensor (2) from housing.
Disconnect connector (3).

Installation:
Replace screw.

IMPORTANT: Do not where possible release cable (4) from holder (5).

Installation:
If holder (5) does have to be released, replace aluminium screw (6).
Tightening torque 28 10 11AZ.







IMPORTANT:
To disconnect combination sensor plug:
Press lock together in area (1) and simultaneously detach plug.

;%�:

�i�:

��: