65 77 720 Removing and Installing/Replacing Left B-pillar Sensor

65 77 720 - Removing and installing (replacing) left B-pillar sensor





Important!
Read and comply with notes on protection against electrostatic damage (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).





Warning!
Note airbag safety instructions [1][2]Safety Regulations For Handling Components With Gas Generators!
Incorrect handling can activate airbag and cause injury.





Necessary preliminary tasks:
- Disconnect battery negative lead 61 20 900 Disconnecting and Connecting Battery Negative Lead and cover
- Remove rear side trim panel Removing and Installing/Replacing Rear Left or Right Lower Side Trim Section





Release screw (2) and disconnect plug connection (2).
Tightening torque 65 77 5AZ Airbag Triggering Control.






Installation Note:
Establish correct positioning of B-pillar sensor (1) by means of guide pin (2) and screw (3).