13 54 544 Removing and Installing/Replacing Right Hall Sensor

13 54 544 - Removing and installing/replacing right Hall sensor (S65)





Necessary preliminary tasks:
- Read out fault memory of DME control unit
- Switch off ignition
- Remove intake air manifold Service and Repair
- Remove secondary-air pump Service and Repair
- Release and raise cable duct for engine wiring harness; for information, refer to Removing engine wiring harness 12 51 001 Replacing Wiring Harness Section for Engine





Unlock and disconnect plug-in contact in wiring harness (not on sensor).
Release screws and detach Hall sensor towards front.

Installation:
Make sure Hall sensor is installed in correct position.

Assemble engine.





Important!
After performing work on the throttle valve system (throttle valve assembly, servomotor, Hall sensor), it is absolutely essential to carry out a throttle valve actuator system test with the BMW diagnosis system!
Function selection:
- Complete vehicle
- Drive
- Engine electronics
- Air supply
- Throttle valves
- Throttle valve actuator





Note:
Check stored fault messages
Clear fault memory