13 54 544 Removing and Installing/Replacing Left Hall Sensor

13 54 544 - Removing and installing/replacing left Hall sensor (S65)





Necessary preliminary tasks:
- Read out fault memory of DME control unit
- Switch off ignition
- Remove intake air manifold Service and Repair





Unlock and disconnect plug-in contact in wiring harness (not on sensor).
Release screws and detach Hall sensor towards front.

Installation:
Make sure Hall sensor is installed in correct position.





Important!
After performing work on the throttle valve system (throttle valve assembly, servomotor, Hall sensor), it is absolutely essential to carry out a throttle valve actuator system test with the BMW diagnosis system!
Function selection:
- Complete vehicle
- Drive
- Engine electronics
- Air supply
- Throttle valves
- Throttle valve actuator





Note:
Check stored fault messages
Clear fault memory