P0342

2716 - P0342

Information saved in
DME

Fault code
2716 - P0342

Fault text
Camshaft sensor, inlet, bank 1

Fault description
Camshaft Position Sensor 'A' Circuit Low (Bank 1 or Single
Sensor)

Condition for fault identification
Test condition:
Less than 5 (K_VAN_RAD_MIN) pulses within an
operating cycle, 10 consecutive operating cycles
Terminal condition: TERM87
Voltage condition:
Battery voltage > 9V (k_ed_ubmin)

Condition for fault memory entry
Every operational cycle

Action in service
2. Check plug and wiring harness to camshaft sensor NWG
B1,
2. Check gap between sensor and reluctor ring
3. Replace camshaft sensor NWG B1.

Fault effect and breakdown warning
MIL on after engine runs 2x

Driver information
Warning light:
MIL

Service instruction
none