P0107

2714 - P0107

Information saved in
DME

Fault code
2714 - P0107

Fault text
Intake-manifold pressure sensor

Fault description
Manifold Absolute Pressure/Barometric Pressure Sensor
Circuit Low

Condition for fault identification
Test condition:
Measured value <= 97 mbar (K_PSAU_DIAG_MIN)
Terminal condition: TERM87
Voltage condition:
none

Condition for fault memory entry
1250 ms

Action in service
1. Check electrical wires for
intermittent open contact
short circuit to ground
2. Read out value measured by sensor with tester
3. Replace idle actuator pressure sensor as indicated
4. Replace engine wiring harness as indicated
5. Clear diagnostic fault codes from fault memory

Fault effect and breakdown warning
MIL on after engine runs 2x

Driver information
Warning light:
MIL, EML, CC message, backup program

Service instruction
none