2714 - P0108 (DME)

2714 - P0108

Information saved in
DME

Fault code
2714 - P0108

Fault text
Intake-manifold pressure sensor

Fault description
Manifold Absolute Pressure/Barometric Pressure Sensor
Circuit High

Condition for fault identification
Test condition:
Measured value >= 1100 mbar (K_PSAU_DIAG_MAX)
Terminal condition: TERM87
Voltage condition:
none

Condition for fault memory entry
1250 ms

Action in service
1. Check electrical wires for
intermittent open contacts,
open circuits,
short circuit to power-supply voltage (+5V)
or ground offset
2. Read out value measured by sensor with tester
3. Replace idle actuator pressure sensor as indicated
4. Replace engine wiring harness as indicated
5. Clear diagnostic fault codes from fault memory

Fault effect and breakdown warning
MIL on after engine runs 2x

Driver information
Warning light:
MIL, EML, CC message, backup program

Service instruction
none