24 13 012 Replacing Output Flange Shaft Seal (GA6HP26Z)
24 13 012 Replacing output flange shaft seal (GA6HP26Z) AWDSpecial tools required:
Important!
After completion of work, check transmission oil level.
Use only the approved transmission fluid.
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Necessary preliminary tasks:
^ Remove transfer box
Drive a hole into radial shaft seal (1) using a center punch.
Important!
Do not use a drill as drillings may result in transmission malfunction.
Thread special tool 23 0 490 into radial shaft seal (1).
Drive out radial shaft seal (1) with impact weight (2).
Installation:
Coat sealing lips of new radial shaft seal with clean transmission oil.
Drive shaft seal firmly home with special tool 24 4 310.