72 11 033 Removing and Installing/Replacing Front Left or Right Seat Belt

72 11 033 Removing And Installing/Replacing Front Left Or Right Seat Belt







Necessary preliminary tasks:
- Remove trim panels for door pillar







Installation:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use







Version with anchor fitting tensioner:

Necessary preliminary tasks:
- Remove outer cover

Release screw (1).
Tightening torque 72 11 07AZ.
Remove lock washer.
Pull belt strap (2) out of end fitting pretensioner.







Version without anchor fitting tensioner:
Move front seat upwards.
Release screw (1) on front seat.

Installation:
Replace screw.

Tightening torque 72 11 02AZ.
Feed out belt anchor fitting (2).







Unfasten screws (2).
Tightening torque 72 11 04AZ.
Remove seat belt guide loop.
Release screws (1).

Installation:
Replace screws (1).
Remove belt deflector.
Tightening torque 72 11 05AZ.
Release screw (1).







Installation:
Replace screw.
Tightening torque 72 11 01AZ.
Unlock automatic reel (2) and remove from B-pillar.

Installation:
Automatic reel is encoded against incorrect installation (3).







Version with electric motor retractor:
Release screws (1).

Installation:
Replace screws.
Tightening torque 72 11 01AZ.
Unlock automatic reel (2) and remove from B-pillar.

Installation:
Retractor mechanism is encoded against incorrect assembly.







Unfasten plug connection (1) and disconnect.
Remove complete seat belt.







Installation:
Carry out function check.

��L:

n: