72 11 070 Removing and Installing/Replacing Front Lower Strap Fitting (Belt Tensioner), Driver's Seat

72 11 070 Removing And Installing/Replacing Front Lower Belt Fitting (Belt Tensioner), Driver's Seat







Necessary preliminary tasks:
- Remove front seat, driver's side







Installation:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use







Unlock and disconnect plug connections (1).







Release screw (1).

Installation:
Replace screw (1).
Tightening torque 72 11 03AZ .
Remove seat belt tensioner.

Installation:
Belt tensioner is coded against incorrect installation.

��L:

n: