67 31 610 Removing and Installing/Replacing Drive For Seat Tilt Adjustment (Comfort Seats In Rear Compartment)

67 31 610 Removing And Installing/Replacing Drive For Seat Tilt Adjustment (Comfort Seats In Rear Compartment)







Necessary preliminary tasks:
- Remove complete padding for rear seat







Installation:
- Powerlok screws must be replaced and must not be reused
- Powerlok screws are mechanical screw locks with trilobular threads







Installation:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use







Unfasten plug connection (1) and disconnect.
Release screw (2).

Installation:
Replace screw (2).
Tightening torque 67 31 13AZ .







Release screws (1).

Installation:
Replace screws (1).
Tightening torque 67 31 12AZ .
Remove drive for seat tilt adjustment (2).







Installation:
Installation position for controlled pan installation.
Adjust position (A) of seat tilt adjustment from rear stop.

A. = 29.4 mm







NOTE: Carry out function check with adapter cable







Replacement only:
Initialise drive unit for seat tilt adjustment.