32 41 331 Replacing Pressure Line For Hydraulic Steering

32 41 331 Replacing pressure line for power steering (from steering gear to junction)





Warning!
Danger of poisoning if oil is ingested/absorbed through the skin!
Risk of injury if oil comes into contact with eyes and skin!

Important!
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off pipe connections with seal plugs.





Recycling:
Catch and dispose of hydraulic fluid in a suitable container.





Necessary preliminary tasks:
^ Draw off and dispose of hydraulic fluid from fluid reservoir
^ Release hydraulic steering gear (F01/F02/F03/F07 only rearwheel drive)
^ Lower front axle support (F04 and all-wheel drive vehicles)





Release screw (1) and remove pressure line (2) from steering gear.

Tightening torque 32 41 5AZ. Mechanical Specifications





Remove return hose (1) from holder (2).





Unfasten screw (1)

Tightening torque 32 41 15AZ. Mechanical Specifications

Release nut (2) on holder.

Tightening torque 32 41 7AZ. Mechanical Specifications

Disconnect pressure line (3).

Installation note:
Replace all sealing rings.

Make sure hydraulic line is laid without tension and with sufficient distance to adjoining components.





After installation:
^ Fill and bleed hydraulic system
^ Check pipe connections for leaks