34 52 162 Removing and Installing/Replacing EMF Actuator

34 52 162 Removing And Installing/Replacing EMF Actuator







Necessary preliminary tasks:
- Release parking brake.
- Switch off ignition.

IMPORTANT: Switch off ignition at least 30 s before disconnecting the plug connection.

After installation, observe the following: switch on ignition and, using parking brake operating element, open parking brake once, close once and open again.







Disconnect plug connection (1).
Disengage cable from cable clip.







Release screws (1).

Installation note:
Replace screws
Tightening torque 34 41 5AZ. 00 00 Excerpt From Company Standard BMW GS 90003-2

Take off holder (2).
Detach actuator drive (3) from brake caliper.







Installation note:
Check sealing ring (1), replace if necessary.

Apply a light coating of brake fluid to sealing ring (1) before fitting.







Installation note:
Carefully fit actuator drive until teeth engage and actuator drive rests flush on brake caliper.
If necessary, turn actuator drive slightly until bore hole and thread are flush.