66 32 020 Removing and Installing/Replacing Sensor For Lane Departure Warning (HC2 Sensor)
66 32 020 Removing And Installing/replacing Sensor For Lane Departure Warning (HC2 Sensor)
Necessary preliminary tasks:
- Remove rear bumper trim
Unlock catch (1).
Remove HC2-sensor (2) from holder.
IMPORTANT:
If, in the event of side damage to the vehicle, it is not necessary to replace the rear apron, observe the following points:
- Mount middle bumper trim guide on undamaged side
- Use middle bumper trim guide as a gauge in order to check or correct the position of the remaining connecting points.
- Middle bumper trim guide must be able to be installed without tension.
Replacement:
- Carry out vehicle programming and encoding.
Replacement/after body repair:
-> Execute diagnosis job
- Initial operation
- SWW sensor system