P1300

2AA2 - P1300

Information saved in
DME

Fault code
2AA2 - P1300

Fault text
Camshaft sensor, inlet, gap loss

Fault description
Camshaft Position Sensor 'A' Segment Timing Error (Bank
1)

Condition for fault identification
Test condition:
NWE synchronous
Terminal condition: Terminal 15 on
Voltage condition:
none

Condition for fault memory entry
On every camshaft flank if the flank ratio is not in tolerance.

Action in service
1. Check signal wire for short to positive, ground, opens and
interference pulses
2. Replace camshaft exhaust side sensor,

Fault effect and breakdown warning


Driver information
Warning light:
MIL 2nd DC,
CAMNone default mode

Service instruction
none