2AA0

2AA0 - P0340

Information saved in
DME

Fault code
2AA0 - P0340

Fault text
Camshaft sensor, inlet, signal

Fault description
Camshaft Position Sensor 'A' Circuit (Bank 1 or Single
Sensor)

Condition for fault identification
Test condition:
NWE synchronous
Terminal condition: Terminal 15 on
Voltage condition:
none

Condition for fault memory entry
On every engine cycle when no camshaft flank has been
detected.

Action in service
1. Check signal wire for short to positive, ground, opens and
interference pulses
2. Replace camshaft exhaust side sensor,

Fault effect and breakdown warning


Driver information
Warning light:
MIL 2nd DC,
CAMNone default mode

Service instruction
none