130F11

130F11 - P0366

Information saved in
DME

Fault code
130F11 - P0366

Fault text
Exhaust-camshaft sensor: signal implausible

Fault description
The diagnostic function monitors the exhaust camshaft
position sensor.

Condition for fault identification
Test condition:
The fault is recognized when the engine is turning over and
camshaft signals have been present.
Potential problem source(s):
- Defect in wiring harness between DME and camshaft
position sensor
- Incorrect gap between camshaft position sensor and
camshaft sensor reluctor ring
- Sensor contaminated or defective
Terminal condition: none
Voltage condition:
- Onboard electrical system voltage between 9 V and 16 V
Temperature condition:
- None
Time condition:
- None
Other conditions:
- Engine ON

Condition for fault memory entry
If the 'crankshaft revolutions' fault is present.

Action in service
- Check wiring harness between DME and camshaft position
sensor
- Check installation of camshaft position sensor and
camshaft position sensor reluctor ring
- Replace sensor

Fault effect and breakdown warning
Breakdown notice:
The engine reverts to its emergency limp-home program,
continued vehicle operation is possible, because power is
reduced the driver should refrain from passing maneuvers.
Possible apparent symptoms:
Extended starting time, power loss, and no restart possible in
combination with an exhaust sensor fault

Driver information
Warning light:
MY10 ECE:
- ECE emissions warning lamp: on
- ECE electronic engine power reduction: off
- CC message: on
MY10 US:
- US emissions warning lamp: on
- US electronic engine power reduction: on
- CC message: on
MY11 ECE:
- ECE emissions warning lamp: on'
-Electronic engine output reduction, ECE: on
- CC message: on

Service instruction
None