67 62 ... Notes on Initializing Power Window Unit In Front Door

67 62 ... Notes On Initializing Power Window Unit In Front Door







WARNING:
Risk of injury.

There is no anti-trapping protection during initialization.







An initialization must be performed:
- In the event of malfunctions, e.g. no one-touch control function, no opening or if available no comfort function is possible
- After the power window drive has been replaced
- After work is carried out on the power window mechanism
- If necessary, after an open circuit, e.g. disconnection of the battery or disconnection of the power supply to the door
- After the door window glass has been removed and installed or replaced
- After adjustment work on the door window glass
- After adjustment work on the convertible top
- After replacement of seals







Initialization is performed on the power window switch of the relevant door.

Requirements for correct initialization:
- Terminal "R" activated
- Doors and windows closed
- Sufficient battery voltage; connect charger if necessary

Initialization comprises:
- Erasure of initialization
- Reinitialization







Erasure of initialization:
- Open door window glass fully
- Actuate power window switch in "Open" position (second switch position) and hold down for between 15 and 20 seconds

This clears initialization of the power window. Anti-trapping protection and one-touch control (toll) function are inactive.

Check whether one-touch control (toll) function is inactive, otherwise repeat procedure.

Reinitialization:
- Close door window completely
- After upper end position is reached, interrupt actuation of power window switch and then hold switch again for approx. 1 second in "Close" position (second switch position)
- Open door window glass fully
- After upper end position is reached, interrupt actuation of power window switch and then hold switch again for approx. 1 second in "Open" position (second switch position)
- Close door window completely
- After upper end position is reached, interrupt actuation of power window switch and then hold switch again for approx. 1 second in "Close" position (second switch position)

This completes initialization.

NOTE: Carry out function check (one-touch control function, anti-trapping protection and, if necessary, comfort function).







NOTE: The power window can also be initialized in the BMW diagnosis system by means of a diagnosis job.