Engine Controls System: 164041

164041 - P13CB

Information saved in
DME

Fault code
164041 - P13CB

Fault text
Exhaust camshaft, mechanism: installation faulty

Fault description
The diagnostic function monitors the installation position of
the exhaust camshaft.

Condition for fault identification
Test condition:
The fault is recognized when the camshaft sensor reluctor
rings run through the adaptation routine during initial start
or following programming.
Potential problem source(s):
- Incorrect installation of exhaust camshaft
Terminal condition: none
Voltage condition:
- Onboard electrical system voltage between 9 V and 16 V
Temperature condition:
- None
Time condition:
- None
Other conditions:
- Engine ON

Condition for fault memory entry
When assembly test is performed.

Action in service
- Install exhaust camshaft correctly
- Adjust valve timing

Fault effect and breakdown warning
Breakdown notice:
The engine reverts to its emergency limp-home program,
continued vehicle operation is possible, because power is
reduced the driver should refrain from passing maneuvers.
Possible apparent symptoms:
None

Driver information
Warning light:
MY10 ECE:
- ECE emissions warning lamp: on
- ECE electronic engine power reduction: off
- CC message: on
MY10 US:
- US emissions warning lamp: off
- US electronic engine power reduction: on
- CC message: on
MY11 ECE:
- ECE emissions warning lamp: off
- ECE electronic engine power reduction: on
- CC message: on

Service instruction
None