Engine Controls System: 160001

160001 - P0335

Information saved in
DME

Fault code
160001 - P0335

Fault text
Crankshaft sensor, signal: no signal

Fault description
The diagnostic function monitors the crankshaft sensor.

Condition for fault identification
Test condition:
The fault is recognized when no crankshaft position sensor
signal is detected, although a signal from the camshaft
position sensor is present.
Potential problem source(s):
- Defect in wiring harness between DME and crankshaft
sensor
- Crankshaft sensor defective
Terminal condition: none
Voltage condition:
- Onboard electrical system voltage between 9 V and 16 V
Temperature condition:
- None
Time condition:
- None
Other conditions:
- Terminal 50 (starter) or,
- engine on, with engine speed > 500 rpm

Condition for fault memory entry
No signal for camshaft revolutions

Action in service
- Check wiring harness between DME and crankshaft sensor
- Replace crankshaft sensor

Fault effect and breakdown warning
Breakdown notice:
The engine reverts to its emergency limp-home program,
continued vehicle operation is possible, because power is
reduced the driver should refrain from passing maneuvers.
Possible apparent symptoms:
When the fault is logged the engine stalls at idle, at higher
engine speeds a brief drop in rpm can be felt / It is possible
to restart engine when the fault is present (starting takes
longer), engine runs in limp-home mode

Driver information
Warning light:
MY10 ECE:
- ECE emissions warning lamp: on
- ECE electronic engine power reduction: off
- CC message: on
MY10 US:
- US emissions warning lamp: on
- US electronic engine power reduction: on
- CC message: on
MY11 ECE:
- ECE emissions warning lamp: on'
-Electronic engine output reduction, ECE: on
- CC message: on

Service instruction
A terminal status switch must be conducted before this fault
can be deleted.