12BD92

12BD92 - P2195

Information saved in
DME

Fault code
12BD92 - P2195

Fault text
Oxygen sensor before catalytic converter, plausibility: fixed
at lean

Fault description
The diagnostic function monitors whether the voltage of the
pre-catalyst oxygen sensor is within a plausible range.

Condition for fault identification
Test condition:
The fault is recognized when the voltage of the pre-catalyst
oxygen sensor remains consistently too high.
Potential problem source(s):
- Defective wiring harness
- Oxygen sensor before catalytic converter defective
- Leak in exhaust system on engine-side of catalytic
converter
Terminal condition: none
Voltage condition:
- Onboard electrical system voltage between 9 V and 16 V
Temperature condition:
- Engine warmed to normal temp, above 80 °C
Time condition:
- None
Other conditions:
- Engine on
- No diagnostic fault codes logged indicating a mixture fault

Condition for fault memory entry
The diagnostic fault code is logged when the fault remains
present for longer than 2 min.

Action in service
- If faults related to mixture control are present, repair these
first
- Check exhaust system for leaks
- Check wiring harness between pre-catalyst oxygen sensor
and DME
- Replace pre-catalyst oxygen sensor

Fault effect and breakdown warning
Breakdown notice:
Continued driving is possible, but because the oxygen
sensor is not ready for closed-loop control, conversion of
exhaust gases in the catalytic converter will be seriously
impaired.
Possible apparent symptoms:
MIL lights up when fault is detected in two consecutive
driving cycles

Driver information
Warning light:
- ECE emissions warning lamp: on
- ECE electronic engine power reduction: on
- CC message: on
- US emissions warning lamp: off
- US electronic engine power reduction: off
- CC message: none

Service instruction
None