33 32 671 Replacing One Rubber Mount In The Upper Control Arm (Control Arm Removed)

33 32 671 - Replacing one rubber mount in the upper control arm (control arm removed)





Special tools required:
- 33 3 351
- 33 3 352





Press rubber mount with special tools 33 3 351 and 33 3 352 out of upper control arm.





Place new rubber mount at chamfered end of control arm bore. Here, longer collar (A = 17 mm) of rubber mount must point upwards.

Press in rubber mount with special tools 33 3 351 and 33 3 352 until flush.





After installation:

- Perform chassis alignment check 32 00 155 KDS Chassis/Wheel Alignment Check With Ride Height Measurement Without Vehicle Load