52 13 400 Seat Cover on Left or Right Front Seat (Normal/Manual)

52 13 400 - Replacing seat cover on left or right front seat (normal/manual)





Special tools required:
- 52 0 050 Tools and Equipment





Necessary preliminary tasks:
- Remove front seat Front Seat, Normal, Manual
- Remove outer cover 52 13 040 Outer Cover on Left or Right Front Seat Backrest (Normal/Manual) on front seat





Warning!
US/CDN front passenger seat (with CIS mat) only:
If CIS mat or padding is defective, both parts must be replaced together.





Important!
The CIS mat must be enabled after each installation operation.

Enabling seat occupancy detector (CIS mat):
- Connect BMW programming system Programming and Relearning
- Code airbag control unit
- Clear fault memory if necessary





Warning!
US/CDN front passenger seat (with CIS mat) only:
To avoid damaging the CIS mat, it is essential to carry out the following operations with extra care.





Important!
Risk of damage on sharp-edged seat mechanism.
Guide all cables carefully through seat and backrest mechanism.
Make sure cable is routed without kinks and tension.
Make sure plug connections are correctly locked.
Make sure plugs are correctly seated in catches.





Version with seat occupancy detector (CIS mat) only:
1. Data line CIS
2. Ground cable, seat shell
3. Ground cable, backrest frame
Unlock all plug connections and disconnect.





Version with seat heating only:
Unlock plug connection (1) for seat heating and disconnect.
Unfasten cable clip.
Disengage wiring harness from cable ties (flexmat).





Version with seat occupancy detector without seat heating (CIS mat) only:
Seat heating is integrated in the CIS mat and is stuck to the padding over the full surface.
Lay cable for seat heating as shown to flexmat and secure with cable tie.





Release screw (1).
Remove trim (2) from inside of seat.





Outside of vehicle:
Lever clip (1) out of seat cover.

Installation:
If necessary, replace faulty clip.





Tunnel side:
Disengage cover fastener (1) from belt deflector trim.





Detach seat cover (1) from seat frame.





Pull out cover welt (1) completely from seat frame (2).





Remove seat cover (1) with padding towards front/top.

Important!
Carefully slide bracing cloth with foam through backrest gap and seat structure.





Version with seat heater and/or with seat occupancy detector (CIS mat):
Pull seat cover (1) with padding forward a little and feed wiring harnesses (2) out.
Remove seat cover (1) with padding towards front/top.





Carefully detach all retainers in side area from longitudinal wires (1).
Pull trim wires (1) forward out of seat cover.
Carefully fold back seat cover and release retainers from cross-wires (2).
Remove seat cover from padding.

Important!
Remove all remnants of clips from seat cover and padding (CIS mat).





Replacement only:
If necessary, cut new seat cover to size and insert trim wires.





Installation:
Bend new clips (2) with special tool 52 0 050.
1. Padding
2. Retainer
3. Trim wire in padding
4. Trim wire in cover
5. Seat cover