27 10 070 Replacing Output Flange on Transfer Box at Rear (ATC 700)

27 10 070 Replacing output flange on transfer box at rear (ATC700)





Important!
After completing work, check gear oil level and top up if necessary.
Use only approved transmission oil for this transfer case.





Note:
^ Operations for removing output flange are identical to replacing radial shaft seal





Installation:
^ Thickness of new shim must be determined before output flange is installed

Determine and note down measurement A of output flange (previous and new).





Determine and note down measurement B of output flange (previous and new).





Determine measurement C, thickness of shim.





Installation:
Calculate thickness of new shim:
1. Add measurement A of output flange (previous) and measurement C of shim (previous)
Then subtract measurement B (previous) from result A+C (previous)
2. Subtract measurement B from measurement A of output flange (new)
3. Then subtract result of step 2 from result of step 1.