24 00 057 Installing Exchange Transmission (GA7AHSCD)

24 00 057 Installing exchange transmission (GA7AHSCD)





Important!
Before replacement, the service function "EWS-TCM adjustment" must be carried out in the BMW diagnosis system.
(Service function/Drive/Hybrid cars/Hybrid transmission/EWS adjustment))





Installation note:
After completion of the work, program the control unit for electronic transmission control (TCM Transmission Control Module).





Drain automatic transmission fluid at oil drain plug (2).

Tightening torque 24 00 4AZ.





Recycling:
Catch and dispose of escaping transmission oil.
Observe country-specific waste disposal regulations.





Necessary preliminary work:
^ Remove transfer box





Important!
- Before installing exchange transmission, always flush transmission oil cooler together with lines.

- After completion of work, check transmission oil level.
- Use only approved transmission oil
Failure to comply with this requirement will result in serious damage to the automatic transmission
Exchange transmissions come filled with oil





Modify transportation retainers.

Convert all cable clips.

Convert all seal plugs.

Convert protective cap on output shaft.

Transmission identification:
- refer to BMW Parts Service.
- On type plate