Seals and Gaskets: Service and Repair

24 13 060 Replacing shaft seal for parking lock shaft (GA7AHSCD)

Special tools required:





Important!
After completion of work, check transmission oil level.
Use only the approved transmission oil.
Failure to comply with this requirement will result in serious damage to the automatic transmission!





Necessary preliminary work:
^ Remove transmission

^ Remove parking lock control unit (DSM)





Screw in special tool 24 5 367 until it is firmly connected with radial shaft seal.





Screw special tool 24 5 362 onto special tool 24 5 367 and tighten down.

This pulls radial shaft seal out of transmission housing.

Oil sealing lip on radial shaft seal.





Drive radial shaft seal fully home using special tool 24 0 350 and plastic hammer.