Securing Engine In Installation Position

11 00 670 Securing engine in installation position (N63)

Special tools required:





Warning!
High-voltage system - danger to life!

Warning!
The following points must be strictly observed prior to starting work:
^ Disconnect high-voltage system from power

^ Observe safety information for handling hybrid cars





Warning!
Risk of injury!
Observe following instructions relating to special tool:
1. Prior to each use, check the special tools for defects, modifications and operational reliability.
2. Damaged/modified special tools must not be used!
3. No changes or modifications may be made to the special tools!
4. Keep special tools dry, clean and free of grease.





Necessary preliminary tasks:
^ Secure engine compartment lid in service position
^ Remove holder for electronics box power module
^ Remove intake filter housing





Assemble transverse member 00 0 200 with special tools 00 0 202, 00 0 204, 00 0 208.

Modification:
Replace profile strips with special tools 00 0 451.

Replace front supports with special tools 00 0 452.

Note:
Ensure that the longer feet of special tool 00 0 452 point to centre of vehicle.





Note:
The support points on the left side are shown.

Position traverse member 00 0 200 with a 2nd person helping on designated areas (1, 2).

Note:
Make sure that the front supports 00 0 452 are correctly positioned on the carrier supports.





Important!
Avoid a change of engine position in the transverse or longitudinal direction.
Always make sure there is sufficient clearance between the engine (or its attachment parts) and the body.





Important!
Risk of damage!
With a 2nd person helping and using supports (1), place transverse member 00 0 200 on screw connections of side panels.

Secure special tool 11 0 000 to spindle 00 0 202.

Attach suitable chains to special tool 11 0 000 and suspend from both engine suspension lugs.





Warning!
Risk of injury!
Tighten down all adjusting screws and nuts on transverse member 00 0 200.





Release nuts (1) on engine mount on left and right.

Tightening torque 22 11 2AZ.

Raise engine approx. 10 mm with transverse member.

Installation:
Replace self-locking nuts.

��#: