24 13 012 Replacing Output Flange Radial Shaft Seal (GA8HP70Z)
24 13 012 Replacing output flange radial shaft seal (GA8HP70Z) AWDSpecial tools required:
Important!
After completion of repair work, check transmission oil level.
Use only the approved transmission oil.
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Necessary preliminary work:
^ Remove transfer box
Drive a hole into radial shaft seal (1) using a center punch.
Important!
Do not use a drill as metal chips may result in transmission malfunction.
Thread special tool 23 0 490 into radial shaft seal (1).
Drive out radial shaft seal (1) with impact weight (2).
Installation Note:
Coat sealing lips of new radial shaft seal with clean transmission oil.
Drive shaft seal firmly home with special tool 23 3 220.