FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

32 41 033 Removing and Installing Power Steering Pump For Power Steering Gear With Active Front Steering

32 41 033 Removing and installing power steering pump for power steering gear with active front steering (N63)





Warning!
Danger of poisoning if oil is ingested/absorbed through the skin!
Risk of injury if oil comes into contact with eyes and skin!

Important!
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off hydraulic lines with plugs.





Necessary preliminary tasks:
^ Draw off and dispose of hydraulic fluid from fluid reservoir
^ Remove belt pulley
^ Remove fan cowl
^ Remove front assembly underside protection





Release union nut (2) and detach pressure line from power steering pump.

Release hose clamp (1) and detach suction line from power steering pump.

Disconnect plug connection on rear side of power steering pump.

Installation:
Make sure hydraulic lines are laid without tension and with sufficient spacing to adjoining components.

Align suction line by way of marking to connection on power steering pump.

Tightening torque 32 41 4AZ.





Release screws (1, 2) and remove power steering pump.

Installation:
Make sure screws are installed in correct positions.
^ Screw (1) M10x50
^ Screw (2) M10x130

Tightening torque 32 41 3AZ.





After installation:
^ Fill and bleed hydraulic system
^ Check pipe connections for leaks

�)� �]� :