51 71 280 Removing and Installing/Replacing Units Compartment Partition Wall

51 71 280 Removing and installing/replacing units compartment partition wall







Necessary preliminary tasks:
- Remove left microfilter housing cover
- Remove microfilter housing (upper part)







Units compartment partition wall, middle:
Remove gasket (1) for engine compartment lid.
Release screws (2, 4).
Remove partition wall (3).

Installation note:
Make sure partition wall is correctly positioned.

Version with N55 engine only:
Seal the units compartment the top centre.







Units compartment partition wall, left:
Release expansion rivet (1).
Release screws (2, 4).
Left only: Unclip connecting line (3).
Remove partition wall (5).

Installation note:
Replace damaged expanding rivet.
Make sure partition wall is correctly positioned.
Make sure screws are installed in correct positions.







Units compartment partition wall, right:
Release clip (1).
Unfasten screws (2).
Remove partition wall (3).

Installation note:
If necessary, replace faulty clip (1).
Make sure partition wall is correctly positioned.
Make sure screws are installed in correct positions.