Removing and Installing/Replacing High-Pressure Nozzle Of Headlight Washer System On Left (Or Right)

61 67 100 Removing And Installing/Replacing High-pressure Nozzle Of Headlight Washer System On Left (Or Right)

Special tools required:







Necessary preliminary tasks:
- Remove front bumper trim.







Use special tool 00 9 340 to lift the cover (1).







Slowly pull out high-pressure nozzle of headlight washer system (1) at cover (2).
Unclip cover (2) in direction of arrow and remove.
Allow high-pressure nozzle of headlight washer system (1) to slide back slowly.







To prevent excessive escape of washer fluid, seal off end of high-pressure line with special tool.13 3 010
Catch any escaping washer fluid if necessary.







Raise retaining bracket (1) and detach high-pressure line (2) in direction of arrow from high-pressure nozzle of headlight washer system (4).
Raise retaining lugs (3) in direction of arrow and feed high-pressure nozzle of headlight washer system (4) towards rear out of front side panel.

Installation:
Keep plug connection for high-pressure nozzle (4) and high-pressure line (2) clean and free from grease.
Make sure high-pressure line (2) is correctly engaged on high-pressure nozzle (4) and high-pressure nozzle (4) correctly seated on front side panel respectively.
Carry out a function test before fitting bumper trim.
If necessary, top up washer fluid.