27 10 070 Replacing Output Flange on Transfer Box at Rear (ATC 450)

27 10 070 Replacing output flange on transfer box at rear (ATC450)





Important!
After completing work, check transmission oil level and top up if necessary.
For this transfer box, use approved transmission oil only.





Note:
^ Replace output flange only together with a new radial shaft seal.
^ Operations for removing output flange are identical to replacing radial shaft seal





Installation Note:
^ Thickness of new shim must be determined before output flange is installed

Determine and note down dimension A of output flange (previous and new).





Determine and note down dimension B of output flange (previous and new).





Determine dimension C, thickness of shim.





Installation Note:
Calculate thickness of new shim:

1. Add dimension A of output flange (previous) and dimension C of shim (previous)
Then subtract dimension B (previous) from result A+C (previous)
2. Subtract dimension B from dimension A of output flange (new)
3. Then subtract result of step 2 from result of step 1.