24 13 013 Replacing Output Flange Shaft Seal (GA6HP19Z)

24 13 013 - Replacing output flange shaft seal (GA6HP19Z)





Special tools required:
- 23 0 490
- 24 4 310 24 4 310 Drift





Important!
After completion of work, check transmission fluid level Procedures.

Use only the approved transmission fluid.

Failure to comply with this requirement will result in serious damage to the automatic transmission!





Necessary preliminary tasks:
- Remove underbody protection
- Remove transfer box 27 10 010 Removing and Installing Transfer Box ATC 700 (Automatic Transmission)





Drive a hole into radial shaft seal (1) using a center punch.

Important!
Do not use a drill as drillings may result in transmission malfunction.

Screw special tool 23 0 490 into radial shaft seal (1).

Drive out radial shaft seal (1) with impact weight (2).





Installation Note:
Coat sealing lips of new radial seal with clean transmission oil.

Drive shaft seal firmly home with special tool 24 4 310 24 4 310 Drift.