31 35 000 Removing and Installing/Replacing Front Stabilizer

31 35 000 Removing and installing/replacing front stabilizer





Necessary preliminary tasks:
^ Remove front wheels
^ Remove front underbody protection
^ Remove front right wheel arch cover (front section)
^ Remove radiator air duct
^ Remove right brake air duct with holder
^ Remove fan cowl
^ Remove heat exchanger from front axle support and tie up
^ Disconnect pressure line for power steering from front axle carrier
^ Remove both anti-roll bar links from anti-roll bar





Release screws (1).

Remove both retaining brackets of stabilizer (2).





Installation:
Align retaining bracket (1) so that tapped holes are situated in middle of elongated hole.

Tightening torque 31 35 1AZ.





Remove radiator box from engine carrier, extend out, press upwards and support with workshop jack.

Important!
Do not damage coating of stabilizer.

Remove stabilizer towards front.

Installation:
Check rubber mounting of radiator box for correct seating.