32 21 151 Replacing Left or Right Tie Rod
32 21 151 Replacing left or right tie rodSpecial tools required:
Note:
If the tie rod end to tie rod screw/bolt connection is released, it is necessary after reinstallation to carry out a wheel/chassis alignment check.
Necessary preliminary tasks:
^ Remove front wheel
Important!
Do not release track rod end from swivel bearing with impact tool.
Make sure special tool rests correctly on steel bushing of swivel bearing.
The swivel bearing must be removed if the steel bushing moves.
Rubber gaiter of tie rod end must not be damaged!
Do not pull stainless steel ring off journal.
Slacken nut (1) two to three thread turns.
If necessary, replace lower section 31 2 242 with lower section 31 2 246.
Press track rod end (2) with special tool 31 2 240 off swivel bearing.
Unscrew nut (1) and remove tie rod end (2) from swivel bearing.
Installation:
Keep tie rod end to swivel bearing connection clean and free from oil and grease.
Replace self-locking nut.
Tightening torque 32 21 3AZ.
Determine measurement (A) to simplify following adjustment of front axle.
Slacken nut.
Unscrew tie rod end from tie rod.
Installation:
Check gaiter for damage, replace if necessary.
Refit clamping ring (1).
Screw tie rod end onto tie rod to measurement (A).
Tightening torque 32 21 2AZ.
After installation:
^ Perform chassis alignment check
^ Carry out steering angle sensor adjustment/adjustment for active steering
