32 41 037 Removing and Installing/Replacing Power Steering Pump For Hydraulic Steering Gear With Dynamic Drive

32 41 037 - Removing and installing/replacing power steering pump for power steering gear with Dynamic Drive (N54)





Warning!
Danger of poisoning 00 .. ... Danger of Poisoning If Oil Is Ingested/Absorbed Through the Skin if oil is ingested/absorbed through the skin!
Risk of injury 00 .. ... Risk of Injury If Oil Comes Into Contact With Eyes and Skin if oil comes into contact with eyes and skin!

Important!
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off hydraulic lines with plugs.





Note:
When replacing power steering pump:
Fluid reservoir Service and Repair must be replaced in event of metal abrasion, sluggish pump shaft or increased wear!
The filter integrated in the fluid reservoir can only absorb a limited amount of foreign particles. If the filter clogs, the hydraulic system can no longer be sufficiently protected.
Metal abrasion is perceived in the fluid reservoir as metallically glittering hydraulic fluid.
It is only necessary to replace the fluid reservoir because of leaks (e.g. at hose connections) only in the event of the unavoidably high ingress of dirt.





Necessary preliminary tasks:
- Draw off and dispose of hydraulic fluid from fluid reservoir
- Remove acoustic cover
- Remove belt pulley 32 41 100 Removing and Installing/Replacing Belt Pulley on Vane Pump For Power Steering
- Remove left charge air line
- Remove steering gear cover at top 51 71 ... Removing and Installing/Replacing Top Left Steering Gear Cover





Release hose clamp (1) and detach suction line from power steering pump.
Version with active front steering: Disconnect plug connection (2).
Release banjo bolt (4) and detach pressure line for Dynamic Drive from power steering pump.
Release banjo bolt (3) and detach pressure line from power steering pump.

Installation Note:
Replace all sealing rings.
Make sure hydraulic lines are laid without tension and with sufficient spacing to adjoining components.
The identification (P) of the suction line and the rib of the power steering pump serve as a rough aid to alignment.
Tightening torque 32 41 4AZ 32 41 Pump and Oil Supply (for power steering).
Tightening torque 32 41 9AZ 32 41 Pump and Oil Supply (for Dynamic Drive).





Remove idler pulley (1).
Release bolts (2) and remove power steering pump towards top.
Tightening torque 32 41 3AZ 32 41 Pump and Oil Supply.





After installation:
- Fill and bleed hydraulic system 32 13 006 Bleeding Power Steering (Version With Dynamic Drive)
- Check pipe connections for leaks
- If necessary, carry out initial Dynamic Drive operation 37 10 001 Initial Operation With Test Run of Dynamic Drive