16 11 071 Replacing Rubber Sleeve Between Fuel Filler Pipe and Fuel Tank

16 11 071 - Replacing rubber sleeve between fuel filler pipe and fuel tank





Recycling
Fuel escapes when fuel lines are detached. Have a suitable collecting container ready.
Catch and dispose of escaping fuel.
Observe country-specific waste-disposal regulations.





Important!
Ensure adequate ventilation in the place of work!
Avoid skin contact (wear gloves)!
Before starting the engine for the first time:
- Fill fuel tank with at least 5 liters of fuel.





Necessary preliminary tasks:
- Draw off fuel from fuel tank Procedures
- Remove underbody panelling 51 47 ... Removing and Installing/Replacing Left or Right Underbody Panelling on right
- Remove rear right wheel arch trim Service and Repair





Unclip line holder (1).
Slacken nut (2).

Installation:
Check plastic nut (2), replace if necessary.
Tightening torque 16 12 2AZ 16 12 Fuel Delivery.





Important!
There may be residual amounts of fuel in the tank!
Catch escaping fuel in a suitable container.

Loosen hose clamps (1).

Detach rubber sleeve first from fuel filler pipe and then from fuel tank.

Installation:
Tightening torque 16 11 3AZ 16 11 Fuel Tank and Mounting Parts.