32 41 331 Replacing Pressure Line For Hydraulic Steering

32 41 331 Replacing pressure line for hydraulic steering (N54/N55)





Warning!
Secure engine in installation position to prevent it from falling down.





Warning!
Danger of poisoning if oil is ingested/absorbed through the skin!
Danger of injury if oil comes into contact with eyes and skin!

Important!
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off line connections with seal plugs.





Recycling:
Catch and dispose of hydraulic fluid in a suitable collecting vessel.





Necessary preliminary work:
^ Draw off and dispose of hydraulic fluid from oil reservoir
^ Lower front axle support





Release banjo bolt (1) and remove pressure line (2) from hydraulic steering gear.

Installation Note:
Replace all sealing rings.

Make sure hydraulic line is laid without tension and with sufficient distance to adjoining components.

Tightening torque 32 41 5AZ.





Expose pressure line up to connection on vane pump.





Release screw (1) and remove pressure line (2).

Installation Note:
Replace all sealing rings.

Make sure pressure line is laid without tension and with sufficient spacing to adjoining components.

Tightening torque 32 41 4AZ.





After installation:
^ Fill and bleed hydraulic system
^ Check line connections for leak tightness

�)��]�: