34 41 220 Removing and Installing/Renewing All Parking Brake Shoes

34 41 220 Removing and installing/renewing all parking brake shoes

Special tools required:





Installation:
^ Remove rear brake disc
^ Release electromechanical parking brake (EMF)

After completing tasks, adjust parking brake.





Disconnect return springs (1) with brake spring pliers.

Installation:
Return springs (1) must not be overelongated.

Check return springs (1) and replace if necessary.

Return springs (1) must not be mixed up.

Pay attention to installation position of adjusting screw (2).

Apply a thin coat of grease to bush and screw threads, refer to BMW Service Operating Fluids.

Note:
Illustration does not show wheel hub.





Twist roll pins (1) 90° with special tool 34 4 000 and detach.

Remove brake pads (2).