51 23 100 Removing and Installing/Renewing Right Bonnet Lock

51 23 100 Removing And Installing/Renewing Right Bonnet Lock







Unclip coupling (1) from side panel.
Lever out cover (2) at coupling (1).
Lever Bowden cable (3) out of coupling (1).







Lever out expander rivets on transverse reinforcement. Press lock (1) and raise intake duct (2). Detach intake duct (2) from air filter housing in direction of arrow and remove.







Unclip Bowden cable (1) from holder (2) on transverse reinforcement.







Release screws on left and right sides of transverse reinforcement (1). Tightening torque 51 71 4AZ. Remove transverse reinforcement (1).







NOTE: Illustration shows A/C lines and module carrier cover removed for purposes of clarity.

Release screws (1).
Tightening torque 51 23 2AZ.
Feed out hood/bonnet lock (2) through opening (3).







Disconnect plug connection (1), unclip plug and cable from body.
Disengage Bowden cable (1) in direction of arrow from hood/bonnet lock (3).

Replacement:
Remove switch (4).