24 00 023 Removing and Installing Automatic Transmission (GA6HP26Z)

24 00 023 Removing and installing automatic transmission (GA6HP26Z)

Special tools required:





Important!
After completion of work, check transmission oil level.
Use only the approved transmission oil.
Failure to comply with this requirement will result in serious damage to the automatic transmission!

Necessary preliminary work:
^ Disconnect battery





^ Secure engine in installation position
^ Remove fan cowl
^ Remove exhaust system
^ Remove front underbody protection
^ Remove reinforcement plate
^ Remove front propeller shaft
^ Remove propeller shaft





Unfasten nut.

Disconnect cable (1).

Installation note:
^ Unfasten nut.
^ Adjust cable by means of holder (2) until distance A = 1 mm is obtained
^ Tighten nut.





Release screws (1).

Secure line (2) under cross-brace (3).

Remove cover (4).

Release screw (1) and remove crankshaft sensor.





Disengage cable from holder (2).





^ Unlock connector (1) by turning and disconnect
^ Release cable from retainers
^ Insert special tool 24 2 390 in sealing sleeve.

These tasks are described in Notes on mechatronics.
(Important: Observe important note)





Release screw (1).

Disconnect hydraulic lines (2) to transmission oil cooler.

Installation note:
Replace sealing rings.

Crank engine at vibration damper until screw (1) is visible in recess.





Release all 6 screws (1) on torque converter.

Tightening torque 24 40 1AZ.





Press special tool 24 1 380 together and insert into recess in transmission housing.





Unlock and detach connectors (1) and (2).

Supporting transmission:
Support transmission with special tools 23 4 050, 00 2 030.





Secure transmission to mounting with tensioning strap (1).

Tasks are described in Transmission bracket.





Release screws.

Tightening torque 22 32 4AZ.

Release screw (1).

Tightening torque 22 32 5AZ.

Remove cross member.





Lower engine with transmission.

Secure engine and transmission in lowered position with engine support beam.

Then support transmission.

Release screws.

Tightening torque 24 00 1AZ.





Unflange transmission.





Installation note:
Check that fitting sleeves (2) are correctly seated.

Replace damaged fitting sleeves.





Installation note:
Rotate torque converter until bore hole in torque converter is flush with bore hole in drive plate.

Flange-mount transmission to engine.

*x0:

oږF�: