11 13 020 Removing and Installing/Replacing Lower Oil Sump Section

11 13 020 Removing and installing/replacing lower oil sump section (S63)





Necessary preliminary tasks:
^ Remove reinforcement plate
^ Remove oil drain plug and drain engine oil.





Unlock plug connection (1) on oil level sensor and disconnect.

Release screws (2) along line.

Tightening torque 11 13 2AZ.

Remove lower oil sump section (3).

Installation:
Clean sealing surfaces.

Replace seal.

Replace screws.

When replacing oil sump bottom section:

Convert oil level sensor.

Replace sealing ring.