66 53 010 Calibrating Reversing Camera

66 53 010 Calibrating Reversing Camera (From 10/2009)







NOTE:
Calibration of reversing camera must be carried out after the following work:
- Removal and installation/replacement of reversing camera
- Body repair work at rear end of vehicle
- Adjusting work at tailgate







IMPORTANT:
Follow instructions and specifications in procedure.
To obtain an optimum result, always adhere to the following conditions:
- Vehicle standing level on headlight aiming station
- Correct tyre pressure (see label on car).
- Vehicle is free of load
- Rear seat bench is unoccupied
- Do not swap seats during calibration
- Steering wheel in straight-ahead position
- Do not move steering wheel







NOTE: Also switch on reversing camera by means of PDC button.

Calibration can only be carried out with the BMW diagnosis system.
Use of a special tool is no longer required from 03/2011.

Service functions:
- Complete vehicle
- Body
- Camera systems