32 41 332 Replacing Delivery Line for Power Steering

32 41 332 - Replacing pressure line for power steering (from cutting line to steering gear) (N62)





Warning!
Secure engine in installation position with special tool Securing Engine In Installation Position to prevent it from falling down.





Warning!
Danger of poisoning 00 .. ... Danger of Poisoning If Oil Is Ingested/Absorbed Through the Skin if oil is ingested/absorbed through the skin!
Risk of injury 00 .. ... Risk of Injury If Oil Comes Into Contact With Eyes and Skin if oil comes into contact with eyes and skin!

Important!
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off pipe connections with plugs.





Recycling:
Catch and dispose of hydraulic fluid in a suitable container.





Necessary preliminary tasks:
- Draw off and dispose of hydraulic fluid from fluid reservoir
- Lower front axle support 31 11 506 Lowering/Raising Front Axle Support





Release banjo bolt (1) and remove pressure line (2) from power steering gear.

Installation Note:
Replace all sealing rings.
Make sure hydraulic line is laid without tension and with sufficient spacing to adjoining components.
Tightening torque 32 41 5AZ 32 41 Pump and Oil Supply.





Expose pressure line up to cutting line on front axle carrier.





Release nut (1) and remove pressure line (2).

Installation Note:
Make sure hydraulic line is laid without tension and with sufficient spacing to adjoining components.
Tightening torque 32 41 11AZ 32 41 Pump and Oil Supply.





After installation:
- Fill and bleed hydraulic system 32 13 006 Bleeding Power Steering Unit
- Check pipe connections for leaks
- Perform chassis alignment check
- Carry out steering angle sensor adjustment/adjustment for active front steering